In nearly all situations, most individuals spend quite a lot of money buying their forklift. Thus, it is extremely essential to take proper care of it in order to protect your investment well into the long run. It is really a good idea to know the procedures which are carried out in taking care of and maintaining this machinery.
By starting up the forklift and listening closely how it runs is among the best ways to tell how good the engine is performing. Like for instance, if there are any misses or knocks, the machinery is defective and this must raise several issues. Furthermore listen carefully for any squealing sounds which come from the belts because these sounds would provide you with a wealth of information.
When doing maintenance, some of the main parts you will have to pay attention to comprise the safety warning devices, horn, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty parts have to be replaced as soon as they are noticed. It is also imperative to check the wiring.
The battery compartment terminals must be cleaned when the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Each cell of the battery should be checked so as to ensure the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter should be regularly replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been completed and new filters have been fitted, visually inspect the drive axle from underneath the equipment. Be sure to grease the axle if there is any grease fitting. Inspect the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. Afterwards, check every other part of the machinery like the wheels. If any type of issue or fault is detected, be sure to deal with it immediately so as to make certain the equipment is running at its safest and optimum levels.