Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts happen every year, according to OSHA and HRSDC reports. Many of these mishaps are caused by operator error. Lack of appropriate equipment maintenance and check causes numerous others. Forklift maintenance and operation is not only the cause of personal injuries, but also of damage to property. Forklifts can damage sprinklers, building structures and overhead pipes, and other machinery when incorrectly utilized. The following day by day inspections should be performed in order to lessen the chance of forklift mishaps.
Turn off the engine before checking different fluid levels: engine oil, fuel, hydraulic oil, coolant and brake fluid. The tires should be checked for signs of wear and tear. Check the tire air pressure. Check the forks' condition. The load backrest must be attached securely. Do a visual check of the top-clip retaining pin and heel. After that carry out an inspection of the mast chains, hydraulic hoses, stops and cables. Make sure that the finger and overhead guards are securely attached.
The LP fueled forklift has propane tanks which need to be checked for damage, rust or corrosion. The battery's electrolyte levels and charge need to be tested every so often. Seat belts have to be checked for wear and tear. Check to make sure the owner's handbook is stored on-board the forklift in a storage compartment. Test the seat belt to make sure the latches are secure. Check the hood latch to make sure that it is working as it should.
To make sure there are no unusual engine sounds, start the engine up and listen for any irregularities. If there are, investigate promptly. Check the steering controls and the accelerator. The service brake and the parking break should be correctly functioning.
The tilt control and drive control must be inspected to guarantee proper functioning in both reverse and forward. Test the functioning of the hoist and lowering control, and the attachment control. Check the lights and horn. Afterward check the defroster, wipers and heater to make sure they are working well. Inspect each and every gauge to find out that it is reading within functional limits.