Change a Propane Tank
Forklifts powered by propane are common in warehouse settings. These forklifts have a propane mount located at the rear of the driver. These tanks have to be replaced every so often since they have limited lifespans. Drivers of forklifts must always utilize caution when handling propane tanks. Compressed gases are dangerous, especially because the gas is flammable. Use caution when removing and replacing propane tank to prevent injury.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn off the valve on the tank. Let the lift truck run until the engine dies. This process burns off the gas in the transfer hose that connects the tank and the engine. Before taking the next steps, wear the correct safety equipment, like for instance insulated gloves made of either leather or neoprene. It is very vital for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The hose of the tank has to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 Leaks could be checked just by applying soapy water to the valve and slightly opening it. If there is a leak, it will cause bubbles to froth from around the valve. If this happens, check the valve area and the connection hose at the nut. The connecting nut must be re-tightened if you detect any leaks around the valve area, and afterward do the leak inspection process once more. Persistent leaks mean that both the nut and connecting hose should be replaced. Then again, if replacing the nut and hose still does not stop the leak, the tank would need to be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. After that you could start the lift truck and continue working.